Dimensions:
Rake of 38 degrees.
4" Stretch downtubes.
24-1/2" backbone.
Material:
1020 DOM (Drawn Over Mandrel) steel tubing.
Legs are 1-3/8" O.D.
Backbone is 1-1/2" O.D.
Seat post is 1-1/2" O.D. with .219" wall thickness.
Special features:
TIG Welded.
Accepts 11" fender and 1984 & later flat side gas tanks.
Accepts Softail® style oil tank.
Accepts 250 rear tire with full width 1.5" belt.
Integral 5th bolt mounting within reinforced offset trans plate.

Included additionally:
Radius style fender struts for 11" fender (not shown).
Heavy duty swing arm, with 1" axle (not shown).
Front oil tank mount.
Rear frame pivot tube and hardware including pivot bearings
& spacers.

NOTE 1: Requires a 1-1/4" engine-to-inner primary spacer.
NOTE 2: Coil mounts and regulator mounts must be
determined by builder.
NOTE 3: Backbone is measured from back of neck to
front of seat plate gusset.