Dimensions:
Rake of 34 degrees.
4" Stretch
downtube.
24-1/2" Backbone.
19-1/2" Length single
downtube.
Material:
1020 DOM (Drawn Over Mandrel) steel
tubing.
Downtube is 1-3/4" O.D. with .219" wall thickness.
Cradle
tubes are 1-3/8" O.D. with .125" wall thickness.
Backbone and seat post
are 1-1/2" O.D. with .219" wall thickness.
Special features:
TIG Welded.
Accepts 11" fender and 1984 & later flat
side gas tanks.
Accepts SoftailŽ style oil tank.
Accepts 250 rear
tire with full width 1-1/2" belt.
Integral 5th bolt mounting within
reinforced offset trans plate.
Included additionally:
Radius style fender struts for 11" fender (not
shown).
Heavy duty swing arm, with 1" axle (not shown).
Front oil
tank mount, polished stainless steel splash guard
with mounting
hardware.
Rear frame pivot tube and hardware including
pivot
bearings& spacers.
NOTE 1: Requires a 1-1/4" engine-to-inner
primary spacer.
NOTE 2: Coil mounts and regulator mounts must be
determined by builder.
NOTE 3: Backbone is measured from back of
neck to
front of seat plate gusset.Downtube is measured
from
bottom of neck to top of cradle tube joint.
